Need Additional Hardware or Attachments?

We have a product listing dedicated to hardware and attachments.  Need replacement screws and threaded posts for your malice clips or tek-lok?  Need extra or replacement retention screw hardware?  Look no further than the Additional Hardware and Attachments listing.

Each set of extra attachments come with the screws and threaded posts you'll need to install them. 

Keep in mind - all of our gear shares the same hole pattern and that hole pattern is the same for malice clips and tek-loks so you can switch between them if you need to!

WE RECOMMEND APPLYING THREAD LOCKER TO ALL YOUR MACHINE SCREW THREADS.  Machine screws have a tendency to vibrate loose over time, all of our attachment method screws (malice clips, tek-loks etc) are pre-treated with thread locker but anything that needs to be adjusted (retention screws on cuffs, double mags, triple mags etc) cannot be pre-treated or you'll negate the ability to adjust them when you get them.  Once you've determined the level of retention you like, set the retention screws in that position with some thread locker (loc-tite, vibra-tite etc).

Please make sure to treat your machine screws and CHECK THEM PERIODICALLY to make sure the thread locker has not worn off.  Reapply thread locker when needed and you'll be good to go!  This goes for all machine screws so check all your other gear as well - often!